R-EVENGE: THE ONLY 100% MADE IN ITALY BAREFOOT COMPANY

We were born barefoot! But walking Barefoot is an experience that most of us have forgotten. Unsuitable footwear has brought the plant of our foot not to recognize anymore as proper the stimuli that the ground releases. Shoes have evolved over time and reach high levels of technology, both in terms of materials and technology applied to the movement, leaving however the sole as a barrier among the foot and the ground. The contact of our foot with the direct ground no longer exists! R-EVENGE, with all its technical socks line, frees the foot from the sole, perfectly respecting the human physiology and his way to walk.

TECHNOLOGY

The experience and constant investments in the R&D department, over the last 10 years, have allowed us to develop a wide range of specific products for all barefoot and non-barefoot sports. The constant collaboration with the best trainers at national and international level allows us to be always ready for new challenges in creating new products specific for all activities and new sports trends.

PERFORMANCE, SAFETY, HYGIENE AND COMFORT ARE OUR AIMS!

R-EVENGE R&D – TEST REPORT N.344102 – RCT RICOTEST (VERONA – ITALY)

References: ISO 13287:2012

Test Recommendations Results
Friction coefficient on wet ceramic
plant forward  ≥ 0,32  0,32
heel forward  ≥ 0,32  0,30
Tiptoe back  –  0,31

R-EVENGE R&D – TEST REPORT N.344102 – RCT RICOTEST (VERONA – ITALY)

References: EN ISO 20344:2011 p.7.2

Test Unit of measure Recommendations Results
Absorption of water  mg/cm2 ≥ 70 132
Water desorption % ≥ 80 99,6

R-EVENGE R&D – TEST REPORT N.344102 – RCT RICOTEST (VERONA – ITALY)

References: EN ISO 20344:2011 p.6.6 – 6,7 – 6,8

Test Unit of measure Recommendations Results
Water vapor permeability  mg/(cm2*h) ≥ 2,0 11,8
Coefficient of water vapor mg/cm2 ≥ 20 95,6

R-EVENGE R&D – TEST REPORT N.344102 – RCT RICOTEST (VERONA – ITALY)

References: UNI EN ISO 12947-2:2000

Test Recommendations Results
Abrasion resistance

Martindale wet, 25 600 cycles

No breakage or hole

formation

First signs of removal of the insert after about 21000 cycles,

at the end of the test some abrasion zones of the anti-slip polymeric inserts begin to be

highlighted.

specimen deterioration
nominal pressure: 12kPa

R-EVENGE R&D – TEST REPORT N.344102 – RCT RICOTEST (VERONA – ITALY)

References: EN ISO 11092:2014

Test Unit of measure Recommendations Results
Resistance to water vapor (Ret)
in stationary conditions (proof of the breathable hot plate)
<6 extremely breathable
side of the specimen in contact with the plate:
inside stocking
7÷13 very breathable 10,155 (VERY BREATHABLE)
Test conditions: (35,0 ± 0,5) ° C
(40±3) % r. h.
14÷20 breathable
single specimen m2· Pa/W 21÷30 slightly transpiring
>31 non-breathable

MATERIALS

We are constantly looking for innovative solutions to improve the quality and technicality of our products and performance.
In collaboration with our suppliers, all selected in Italy, Silver, Copper, Carbon are just some of the materials used to make our products for indoor and outdoor activities, for adults and children, for professionals but also for all those who they like to play sports and keep fit a few hours a week and in their free time.